Invacare Mobility Aid Tracer 9000 User Manual

Back Extension - InvacareTracer SX,9000,and XT  
Assembly,Installation and Operating Instructions  
Back  
SAVE THESE INSTRUCTIONS  
NOTE: Check all parts for shipping damage before using.  
In case of damage, DO NOT use the equipment. Contact  
the Dealer/Carrier for further instructions.  
DETAIL “A”  
Upholstery  
Washer  
Mounting Holes  
Mounting  
Screws  
SAFETY SUMMARY  
The following recommendations are made for the  
safe use of the Back Extension:  
Back Upholstery  
DETAIL “B”  
GENERAL WARNING  
Back Cane  
DO NOT insta ll or use this e quipme nt without  
first re a d ing a nd und e rsta nd ing the se  
instruc tions. If you a re una ble to unde rsta nd  
the Wa rning s, Ca utio ns o r Instruc tio ns,  
c o nta c t a he a lthc a re p ro fe ssio na l, d e a le r  
o r te c hnic a l p e rso nne l b e fo re a tte m p ting  
to insta ll this e q uip m e nt - othe rwise , injury  
o r d a m a g e m a y o c c ur.  
Back Extension  
Bracket  
Upper Mounting  
Hole  
Lower Mounting  
Hole  
Mounting  
Screws  
Washer  
FIGURE 1 - INSTALLING THE BACK  
EXTENSIO N BRAC KETS  
INSTALLATION WARNING  
Afte r ANY a djustme nts, re pa ir or se rvic e a nd  
BEFORE use , m a ke sure tha t a ll a tta c hing  
ha rd wa re is tig hte ne d se c ure ly.  
INSTALLING THE BACK EXTENSION  
(FIGURE 2)  
This kit includes the following:  
1. Alignthebackextensioninserttubeswiththebackexten-  
sion brackets on the wheelchair as shown in FIGURE 2.  
ITEM  
QUANTITY  
Back Extension Brackets  
Back Extension  
Mounting Screws  
Washers  
2
1
2
2
NOTE:Fasteningstripsshouldfacetherearofthewheelchair.  
2. Seat the insert tubes firmly into position in the back  
extension brackets.  
INSTALLING THE BACK EXTENSION  
BRACKETS (FIGURE 1)  
NOTE:Makesurethatthewheelchairisunfoldedonalevel  
surface, with the wheel locks engaged.  
NOTE:Alignmentnotchesshouldsitfirmlyonthealignment  
screws. Insert tubes should NOT rotate in back extension  
brackets.  
Fastening Strips  
Back Extension  
Insert Tube  
1. Remove the upper two (2) mounting screws and  
washers securing the back upholstery. Refer to  
DETAILAinFIGURE1.  
Back Extension  
2. Align the upper and lower mounting holes in the back  
extension brackets with the upper two (2) mounting  
holesinthebackupholsteryandbackcanes. Referto  
DETAIL “B” in FIGURE 1.  
Insert Tube  
Alignment  
Notch  
Alignment  
Notch  
NOTE: The back extension brackets accommodate several  
models of chairs, replace only the mounting screws that are  
removed. An extra set of screws is included for instances  
of loss or damage.  
Alignment  
Alignment  
Screw  
Screw  
3. Install the two (2) existing mounting screws and washers  
as shown in DETAIL “B”. Tighten securely.  
Back Extension Brackets  
4. Repeat for opposite side.  
FIGURE 2 - INSTALLING THE BACK EXTENSION  
Invacare Corporation  
USA  
Canada  
One InvacareWay  
Elyria,Ohio USA  
44036-2125  
5970 ChedworthWay  
Mississauga, Ontario  
L5R 3T9, Canada  
905-890-8838  
Invacare and "Yes,you can" are trademarks of Invacare  
Corporation.  
© 2000 Invacare Corporation  
800-333-6900  
Form No. 00-107 Part No. 1098351 RevA (1) 6/00  
 

Indesit Washer WME 126 User Manual
InFocus Projector Accessories QR68561 User Manual
Intel Network Card SX38P2 Pro User Manual
JL Audio Car Speaker SB GM SLVCRW 10W1v2 User Manual
JVC Blu ray Player LT 42B300 User Manual
JVC Flat Panel Television LT 52X899 User Manual
JVC Stereo System 0406KMMBICSAM User Manual
Kenwood Speaker XXV 04S User Manual
Kenwood Stereo Amplifier KAC 5020 User Manual
Kenyon Ventilation Hood B81200 Series User Manual