Kompernass Work Light KH4077 11 07 V1 User Manual

6
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM  
ID-Nr.: KH4077-11/07-V1  
 
 
KH 4077  
w
q
e
g
r
f
t
d
y
u
1!  
a
o
i
 
 
 
CONTENT  
PAGE  
Safety instructions  
Description of the appliance  
Assembly  
2
3
3
4
4
4
4
5
5
5
5
Removing the halogen lamps.  
Inserting the halogen lamps  
Cleaning  
Troubleshooting  
Disposal  
Technical data  
Service  
Importer  
Read these operating instructions carefully before using the appliance for the first time and preserve this  
maual for later reference. Pass this manual on to whoever might acquire the appliance at a future date.  
- 1 -  
 
HALOGEN WORK  
SPOTLIGHTS  
ƽ Danger of injuries  
• If they have not previously been supervised or in-  
structed in its correct usage, do not allow indivi-  
duals (including children) to use the appliance  
whose physical, sensorial or mental abilities or  
lack of experience and knowledge hinder their  
safe usage of it if they have not previously been  
supervised or instructed in its correct usage.  
• Inform children about the appliance and its  
potential dangers and that they should not play  
with it.  
Safety instructions  
ƽ Danger of electrical shock!  
• Only connect the Stand Halogen Floodlight to  
correctly installed wall sockets having a mains  
current of 220 - 240 V at 50 Hz.  
• Unplug the Stand Halogen Floodlight from the  
socket if you notice any faulty operation and  
when you decide to clean it.  
• Under no circumstances may the Stand Halogen  
Floodlight be immersed in liquids, or liquids be  
permitted to permeate into the housing.  
Should liquids nonetheless gain entry into the  
appliance housing, immediately unplug the ap-  
pliance from the mains supply and arrange for it  
to be repaired by qualified specialists.  
ƽ Attention  
• Always remove the plug from electrical sockets  
before exchanging the halogen lamps.  
• Allow the halogen lamps to cool before  
removing them.  
• Switch the Stand Halogen Floodlight off only  
with the ON/OFF switch.  
• Never touch the glass covering, the power cable  
or the metal housing whilst it is in operation.  
These parts of the appliance will become very  
hot during use.  
• Never touch the Stand Halogen Floodlight,  
power cable or plug with wet hands  
• To unplug the appliance, always pull the plug  
from the socket, do not pull the cord itself  
• Do not crease or crimp the power cable and  
place it in such a way as to prevent anyone from  
stepping on or tripping over it.  
• To avoid the risk of injury, arrange for defective  
power plugs and/or cables to be replaced as  
soon as possible by a qualified technician or by  
our Customer Service Department to avoid the  
risk of injury.  
To avoid burn injuries, do not touch these  
surfaces!  
• Arrange for a defective glass cover to be imme-  
diately replaced by a suitable new one.  
• Never direct the halogen floodlights towards  
each other. The appliance could be damaged  
by the large generation of heat.  
• Always ensure that the Stand Halogen Flood-  
light is sufficiently distant from yourself and easi-  
ly meltable items.  
• Separate your Stand Halogen Floodlight from  
the mains supply immediately after use.The  
appliance is only completely switched off after  
having been unplugged.  
• To avoid eye damage, do not look directly into  
the Stand Halogen Floodlight.  
• Never place the Stand Halogen Floodlight in the  
close proximity of easily inflammable materials.  
• Use exclusively halogen lamps up to 500 Watt.  
• Never touch the lightbulb with bare hands.  
Always use a dry lint-free cloth.  
• Read and observe all safety and operating  
instructions.  
• Ensure that the Stand Halogen Floodlight has  
cooled down before storing it away.  
Download from Www.Somanuals.co-m2.-All Manuals Search And Download.  
Description of the appliance  
Assemble the protective grill on to  
r
the halogen spotlights  
e
ON/OFF Switch  
Floodlight lever  
Halogen floodlight  
Protective grill  
Knurled screw  
Crossbeam  
³ Insert the lower pegs of the protective grill  
q
w
e
r
t
y
u
i
o
a
s
d
f
g
r
into the recesses on the corners before the glass  
covering  
.
g
³ Squeeze the protective grill  
so far together  
r
that the pegs on the other side of the protective  
grill can be inserted into the recesses there.  
³ Do the same with the second halogen spotlight  
Telescopic stand  
Power cable  
Knurled screw  
Fixing ring  
Mounting the halogen floodlights  
on the crossbeam.  
e
Distributor box  
Knurled screw  
Fixing screw  
³ Insert the knurled screw  
with the washer  
t
through the hole in the bracket of the halogen  
floodlight  
.
e
Glass cover  
³ Insert the halogen floodlight  
with the knurled  
e
screw  
in the pre-drilled hole on the crossbe-  
t
am . Ensure that the Stoppers are located be-  
y
Assembly  
hind the halogen floodlights  
.
e
³ Turn the knurled screw until it is tight.  
t
ƽ Danger of electrical shock  
Assembling the crossbeam on the  
telescopic stand.  
Never insert the plug into an electrical socket until  
the appliance has been completely assembled.  
³ Insert the knurled screw  
first of all through the  
d
hole in the distributer box , then through the  
s
ƽ Danger of burns  
hole in the crossbeam  
³ Now assemble the crossbeam  
.
y
Only touch the halogen lamps when they are in a  
switched-off and cooled-down condition. The halo-  
gen lamps will get very hot. Never touch the light-  
bulb with bare hands, always use a clean and dry  
lint-free cloth.  
and the distri-  
y
butor box  
with the assistance of the knurled  
s
screw  
on the telescopic stand  
.
u
d
³ Turn the knurled screw until it is tight.  
d
Adjusting the height of the Stand  
Halogen Floodlight  
Opening up the pedestal base  
³ To set up the telescopic stand , loosen the  
³ Loosen the fixing ring  
by turning it in an  
u
a
knurled screw, . The pedestal base can now  
anti-clockwise direction.  
o
be opened out to the floor.  
³ Adjust the telescopic stand  
to the desired  
u
³ Turn the knurled screw until it is tight.  
height.  
o
³ Retighten the fixing ring  
by turning it in a clok-  
a
kwise direction.  
- 3 -  
 
ƽ Important!  
Inserting the halogen lamps  
To adjust the halogen floodlight , use the knurled  
e
screw , the fixing screw  
and the floodlight  
1. Ensure that the Floor Halogen Floodlight is  
switched-off and completely cooled down.  
2. Take the new halogen lamp from its packaging  
with a dry cloth. Place a ceramic end on the  
appropriate retainer.  
t
f
lever  
.
w
The horizontal position is adjusted in that the knur-  
led screw is loosened and, with the assistance of  
t
the floodlight lever , it is placed in the desired  
3. Place the other ceramic end on the opposite  
retainer. Ensure that contact has been made  
on both sides. The retainers should now hold the  
halogen lamp securely, such that the halogen  
lamp can no longer move itself.  
w
position. Retighten the knurled screw  
optimal position has been found.  
when the  
t
The vertical position is adjusted in that the fixing  
screw is loosened and and, with the assistance  
4. Now close the glass cover  
retighten the middle screw.  
and replace and  
f
g
of the floodlight lever , it is placed in the desired  
w
position. Retighten the fixing screw,  
optimal position has been found.  
when the  
5. Switch the Floor Halogen Floodlight on with the  
ON/OFF switch  
f
.
q
6. Should it not function, repeat steps 1- 5.  
ƽ Important!  
During the adjustments always hold the floodlight  
lever  
firmly.  
Cleaning  
w
ƽ Important!  
Do not use extension cables that are longer than  
15 m.  
ƽ Danger of electrical shock  
Always remove the plug from the socket before cle-  
aning the Stand Halogen Floodlight.  
Under no circumstances may the appliance be  
immersed in water or held under running water  
during cleaning.  
Removing the halogen lamps.  
1. Switch the appliance off with the ON/OFF  
Clean the exterior of the Stand Halogen Floodlight  
with a moist cloth.  
switch , remove the plug from the socket and  
q
allow the Floor Halogen Floodlight to cool  
down.  
ƽ Attention!  
2. Remove the middle screw on the top of the lamp  
Ensure the Floor Halogen Floodlight is inaccessible  
for children.  
housing. Loosen the glass cover  
.
g
3. Use a dry cloth to take out the halogen lamp.  
4. Remove the halogen lamp.  
Download from Www.Somanuals.co-m4.-All Manuals Search And Download.  
Troubleshooting  
Technical data  
Symptom:  
Mains voltage: 220 - 240 V / 50 Hz  
~
Rated output: 2 x 500 Watt  
Protection rating:IP44  
The Stand Halogen Floodlight will not switch on.  
Possible cause and remedy:  
Check if the Stand Halogen Lamp has been correct-  
ly assembled or if it is possibly damaged. Replace  
the halogen lamps if necessary.  
Service  
DES Ltd  
A domestic electrical fuse is defect.  
Check the domestic fuses and, if necessary, renew  
them.  
Units 14-15  
Bilston Industrial Estate  
Oxford Street  
Bilston  
The power socket is defective.  
Try another wall socket.  
WV14 7EG  
Tel.: 0870/787-6177  
Fax: 0870/787-6168  
The Floor Halogen Floodlight is possibly defect.  
Check the connecting lead and the power plug for  
damages. Have the Floor Halogen Floodlight chek-  
ked over by specialists.  
Irish Connection  
Harbour view  
Howth  
Co. Dublin  
Disposal  
Tel: 00353 (0) 87 99 62 077  
Fax: 00353 18398056  
Do not dispose of the appliance in your  
normal domestic waste.  
Importer  
Dispose of the appliance through an approved dis-  
posal centre or at your community waste facility.  
Observe the currently applicable regulations.  
In case of doubt, please contact your waste disposal  
centre.  
KOMPERNASS GMBH  
BURGSTRASSE 21  
D-44867 BOCHUM  
Dispose of all packaging materials in an  
environmentally responsible manner.  
- 5 -  
 

Intel Laptop W476 User Manual
JVC CD Player KS FX772R User Manual
JVC Digital Camera GR D870U User Manual
Kalorik Mixer CMM 39732 User Manual
Kenwood Weather Radio TM 732A User Manual
Kidco Safety Gate G150 User Manual
KitchenAid Beverage Dispenser KUWO244PBL00 User Manual
KitchenAid Blender KSB580CR0 User Manual
Knoll Systems Projection Television HD282 User Manual
Kramer Electronics Video Gaming Accessories vs 1x1 User Manual